Honda V45 MAGNA-VF750C 1982 User Manual

-
Removlt the camshaft holder dowel pins and the
intake and exhaust camshaft.
Remove the
cam sprockets from the camshafts.
Note the side each camshaft sprocket flange
is
facing for reassembly purpose.
CAMSHAFT/CAM HOLDER
INSPECTION
Inspect the camshaft and holder journal surfaces
for scoring scratches, or evidence of insufficient
lubrication.
CAMSHAFT RUNOUT
Check camshaft runout with a dial indicato r.
Support both ends of the camshaft with V-blocks.
Use 1/2 of the lotal indicator reading to determine
rUMuI.
S ER V ICE LIMIT : 0.10 mm (0. 004 in)
Date of Issue: May, 1982
© HONDA MOTOA CO., L TO .
-- -- .-
CYLINDER HEADN ALVE
INTAKE CAMSHAH
DD'NE L PI NS
,
I
EXHAUST CAMSIHAi Fi'
' 39
10-5

Honda V45 MAGNA-VF750C 1982 Specifications

General

Bore x Stroke	70.0 mm x 48.6 mm
Compression Ratio	10.5:1
Cooling System	Liquid cooled
Transmission	6-speed
Final Drive	Shaft
Front Suspension	Telescopic fork
Rear Suspension	Dual shocks
Front Brakes	Dual disc
Rear Brakes	Drum
Rear Tire	130/90-16
Seat Height	765 mm (30.1 inches)
Fuel System	4 x 32mm Keihin carburetors