Honda V45 MAGNA-VF750C 1982 User Manual

•
.-
W SONDA
~ V45 ~!:::
VALVE GUIDE REPLACEMENT
Heat the cylinder head to l{xtc (212°F) with a
hot plate or ol/en.
CAUTION:
Do 'lOt use a torch to heal the cyli nd er;
it may cause warping.
To avoid burlU, wear heaJry gloves when
handling the heated cylinder heud.
Support the cylinder head and drive out the old
guides from the combustion chamber side of the
cylinder head.
Drive new guides in from the rocker arm side of
the cylinder head.
NOTE:
Cylinder head heat should still be at l00 "C
1212°Fl for installation of the new guides .
Let the cylinder head cool to room temperature
and ream the new valve guides.
NOTE.
Use cutting od on the reamer dur ing this
operation.
Rotate the reamer when inserting Bnd
removing it .
Reface the valve seat (page 10 ·14) and clean the
cylinder head thoroughly to remove anv metal
particles.
Date
of Issue: October, 1982
© HONDA MOTOR CO., l TO.
-
CYLINDER HEAD/VALVE
VALVE GUIDE DRIVER, 5.5 mm
07742-0010100
VALVE GUIDE DRIVER
07942 -3 290200 or 07742-0020200
VALVE GUIDE REAMER
•
1<,
10-13
----_.-

Honda V45 MAGNA-VF750C 1982 Specifications

General

Bore x Stroke	70.0 mm x 48.6 mm
Compression Ratio	10.5:1
Cooling System	Liquid cooled
Transmission	6-speed
Final Drive	Shaft
Front Suspension	Telescopic fork
Rear Suspension	Dual shocks
Front Brakes	Dual disc
Rear Brakes	Drum
Rear Tire	130/90-16
Seat Height	765 mm (30.1 inches)
Fuel System	4 x 32mm Keihin carburetors