Honda V45 MAGNA-VF750C 1982 User Manual

REAR WHEEL/SUSPENSION/BRAKE
Remove the shock from the prMS.
Remove the hose and reinstall the air valve stem.
Place the all Seal Driver on the oil seal.
Place the shock absorber on the press using the Oil
Seal Driver Attactlment.
Press the oil seal out bV compressing the shock
absorber.
CAUTION
Place the shock abgorbu in the hydraulic
press on its upper clevis, not on itt azse.
NOTE
• Spill as little ATF IS possible to prevent air
from ente ring the shock. Air in the shock
will cause the damping to be too soft.
o The oil seal wilt not be pressed out if there
is air in the ATF or if the shock absorber is
not completely filled with ATF.
Remove the oil seal and case guide.
Cheek the case guide for weer or damage.
ASSEMBLY
OUST SEAL
~
-----~
----
LOWER MOUNT
BUSHING
;1 ;:
17-12
-
---
--
~
HONDA.
V45
SABRE
MAGNA
OIL SEAL
DRIVER
VALVE
AIR VALVE
UPPER MOUNT BUSHING
DUST
SEAL
.___CA"E GUIDE
SEAL
~ ____ ------·BI'C" .U PPlATE
------ STOP RING
r-- ____ BOOT
Date of 'nue; May, 1982
© HONDA MOTOR CO., lTD .
- ---- ..... --
-- -
-

Honda V45 MAGNA-VF750C 1982 Specifications

General

Bore x Stroke	70.0 mm x 48.6 mm
Compression Ratio	10.5:1
Cooling System	Liquid cooled
Transmission	6-speed
Final Drive	Shaft
Front Suspension	Telescopic fork
Rear Suspension	Dual shocks
Front Brakes	Dual disc
Rear Brakes	Drum
Rear Tire	130/90-16
Seat Height	765 mm (30.1 inches)
Fuel System	4 x 32mm Keihin carburetors