Honeywell AlarmNet 360 - DEVICE PROGRAMMING Program Replace Device(Central Station and Dealer)

AlarmNet360 Online Help Guide
– 32 –
Contents
Tasks
DEVICE PROGRAMMING ► Program/ Replace Device(central station and dealer)
This is a wizard base tool that enables you to program a new GSM, i-GSM, or internet only communication device. The
steps included in this tool are specifically tailored to task being accomplished. As you start to enter data, such as the
MAC ID, AlarmNet will recognize the type of device and generate the next appropriate wizard screen.
Have the following information ready:
• Subscriber Account Number.
• MAC ID and CRC – For most communicators these are on the product carton, on the product’s PCB, or can be
obtained using the 7720P Programming Tool.
For TUX series devices, these are on the product carton, on the device back, or can be
obtained by tapping the “tools” icon on the home screen. Then tap the “information” icon
on the next screen.
• A name for the TC2 account.
1. Since this is a wizard based tool, just select the service you want for the
account, and click Next. Follow the screen prompts.
2. If the new account will include Total Connect, about midway through
the wizard a check box appears allowing you to Pre-Configure the TC
2.0 account for the customer.