Honeywell GENT Nano panel-based - Table of Contents

Contents
Preliminary information ----------------------5
Safety information ----------------------------- 5
Abbreviations-------------------------------- 5
Pre-visit checks ------------------------------- 6
Points to remember ----------------------------- 6
System commissioning process ------------------7
Controls and indications ----------------------9
Factory default settings ----------------------10
Devices----------------------------------- 10
Modes of operation ----------------------------- 10
Access levels -------------------------------- 10
External circuits------------------------------- 10
Zones ----------------------------------- 10
Immediate Cause and Effect ------------------------- 10
Day mode delay------------------------------- 10
Delayed Cause and Effect -------------------------- 10
External Wiring --------------------------11
Preparation for first power up -------------------13
Links -------------------------------14
Flash Memory protect link P9 ------------------------ 14
Buzzer enable/disable link P5 ------------------------ 14
Lithium battery --------------------------15
12V 7Ahr batteries ------------------------16
Location of Fuses -------------------------17
Loop circuit connect END 1 only -----------------18
Power up -----------------------------19
How to adjust the LCD Contrast ------------------20
How to change to another Access level from access level 1 -----20
How to exit to Access Level 1 from Access level 2,3 or 4 ------20
How to change the user PIN code (Password or Usercode)------21
How to set the 'Clock' -----------------------21
How to conduct a 'Display Test' ------------------22
How to view the panel 'Firmware' -----------------22
How to view the 'Historic' events log ----------------22
Address allocation ------------------------23
How addresses are allocated to devices -------------------- 23
Address allocation from Loop END 1 --------------------23
Address allocation from Loop End 2 --------------------- 23
Allocation faults ------------------------------ 23
Start Up ---------------------------------- 23
How to manually 'Power-down' or 'Power-up' the loop -------24
How to manually 'Start Detection' after manual power-up ------24
How to view the 'Loop Status' -------------------25
How to view the 'Loop Map' and 'Enable / Disable' Devices -----25
How to 'Find Devices' on the Loop circuit -------------26
How to 'Print' the Loop map --------------------27
How to 'Back-up' site data to Flash memory ------------28
How to 'Restore' configuration data from Flash memory -------28
How to view 'Diagnostics' data-------------------29
How to view 'Site data' version-------------------29
Measuring the loop cable resistance and capacitance --------30
When to use the 'Repair' function on the loop circuit --------30
Loop 'Short Circuit' test ----------------------31
Loop 'Ground Break' test ---------------------31
Loop 'Positive line' break test -------------------32
Loop 'Earth fault' tests -----------------------32
To 'Save loop map' and make 'SAFE' device addresses -------33
To 'Clear loop map' and 'UNSAFE' saved addresses from loop devices 33
Insertion of new devices on a 'Saved' loop map -----------34
Difference between Nano panel at V1.00 and V1.3X --------35
Zoning devices ------------------------------- 35
Feature changes ------------------------------- 35
New features -------------------------------- 35
Commissioning instructions
2 4188-949 issue 3_05/10_Nano Comms inst.
Contents