Honeywell GENT Nano panel-based - How to change the user PIN code (Password or Usercode)

How to change the user PIN code (Password or Usercode)
You will need to be at the appropriate Access level 3 or 4 to be able to change the Access level PIN codes. Access level 1 has no PIN code assigned.
Factory default PINs are:
¨
Access level 2 - 0000(Customer mode)
¨
Access level 3 - 3333(Engineering Mode)
¨
Access level 4 - 4444(Maintenance Mode)
How to set the 'Clock'
The 'clock' sets the time and date, which is used by the panel to display the exact time and date of an active event of Fire, Fault or Disablement. The event information along with time and date is logged
in the historic log for future reference. You will need to be at Access level 2 or above to set the clock.
4188-949 issue 3_05/10_Nano Comms inst. 21
Nano panel based system
How to change the user PIN code (Password or Usercode)
Menu
Select
System >
Select
Settings
Clock
Select
10:15 Mon 15/02/10
System Clock
Current Time : [12]:[30]
Current Date : [15]/ [ 2]/[2010]
Current Day : Monday
Save Quit
Save
Enter the current time in hours and minutes
Enter the date
The day of the week is displayed here
To scroll range
To move to
next setting
Menu
Select
System >
Select
Settings
Access Codes
10:15 Mon 15/02/10
Change PIN Code
Existing Code : [0***]
New Code : [****]
New Code (Confirm) : [****]
Save Quit
Select
Save
After making changes to this form you will need to back-up the data to
memory. Ensure the write protect link P9 on the MCB is configured in
the ENABLED position to allow back-up of data.
You can change Access Level 2 code
and Access Level 3 code
when you are at Access Level 3.
To scroll to the required number
from a range 0-9 for each
character (PIN code) position.
To move to the next
character position.