Honeywell GENT Nano panel-based - How to return all Labels to factory default settings; How to return the Configuration and Labels to factory default settings

How to return all 'Labels' to factory default settings
It is possible to reset all the labels entered back to factory default settings. You will need to be at access level 4 to reset labels.
How to return the 'Configuration and Labels' to factory default settings
It is possible to reset all the labels entered and system configuration back to the factory default settings. You will need to be at access level 4 to reset configuration and labels.
4188-949 issue 3_05/10_Nano Comms inst. 65
Nano panel based system
How to return all 'Labels' to factory default settings
Select
System >
Select
Select
Engineering
Default >
Select
Select
All
SelectSelect
16:15 Tue 16/02/10
WARNING! - This will reset all config
data to the factory default settings
including labels!!
This will also erase FLASH backup!!
ARE YOU SURE YOU WISH TO PROCEED?
Yes No
Menu
Yes
After labels and configurations are reset you will need to back-up the
data to memory. Ensure the write protect link P9 on the MCB is
configured in the ENABLED position to allow back-up of data.
After labels and configurations are reset you will need to
power down and power up the panel.
Select
System >
SelectSelect
Engineering
Default >
SelectSelect
Labels
SelectSelect
16:15 Tue 16/02/10
WARNING! - This will reset all labels
to their factory default settings!
ARE YOU SURE YOU WISH TO PROCEED?
Yes No
Menu
Yes
After labels are reset you will need to back-up the data to memory.
Ensure the write protect link P9 on the MCB is configured in the
ENABLED position to allow back-up of data.