Honeywell SmartLine ST 700 - Safety Certification Information; Transmitter Adjustments; Display Options -Standard Display; Table 30 - ST 700 Basic Transmitter - Available Display Characteristics

Page 122 ST 700 SmartLine Pressure Transmitters User’s Manual Revision 13
10.4 Safety Certification Information
An “Approvals” name plate is located on the bottom of the Electronics Assembly; see Figure 42 exact
location. The approvals name plate contains information and service marks that disclose the
transmitter compliance information.
See Appendix A of this document for safety certification requirements and details.
10.5 Transmitter Adjustments
Zero and Span adjustments are possible in ST 700 basic transmitter with the optional external
2-button and integrated two-button assemblies. See Figure 42 for the external 2-button assembly.
You can also use the Honeywell MC Toolkit or other third-party hand-held configurator to make
adjustments to the ST 700 basic transmitter. Alternately, certain adjustments can be made through the
Experion or Universal Station, if the transmitter is digitally integrated with a Honeywell Experion or
TPS system.
10.6 Display Options – Standard Display
Table 29 – ST 700 Basic Transmitter - Available Display Characteristics
Standard
Display
• 360
o
rotation in 90
o
Increments.
• 2 lines, 8 characters
o Standard units of measurement: Pressure Units: atm, bar, ftH
2
O68F,
gf/cm
2
, inH
2
O39F, inH
2
O60F, inH2O68F, inHg0C, kgf/cm
2
, kPa, mbar,
mmH
2
O4C, m, mH
2
O68F, mmHg0C, MPa, Pa, psi, Torr, mH
2
O4C,
cmH
2
O4C.
o Flow Units (DP models only): m3/hr, Kg/hr, MT/hr, L/sec, L/hr, SCFH,
CFH, gal/hr, bbl/hr, Igal/hr, %, SCFD, gal/min, lb/hr, lb/min, SCFM,
MSCFH, MMSCFH.
• Diagnostic messaging.