Revision 12 ST 700 SmartLine Pressure Transmitters User’s Manual Page 141
12.6.4 Procedure to Install Flange Adapters
The following procedure provides the steps for removing and replacing an optional flange adapter on
the process head. Refer to
Figure 53.
This procedure does not require that the Meter body be removed from the electronics
housing. If flange adapters are being replaced with parts from other kits (for example,
process heads), follow the procedures for the kits and incorporate the following procedure.
The threaded hole in each flange adapter is offset from center. To ensure proper orientation
for re-assembly, note the orientation of the offset relative to each process head before
removing the adapter.
Figure 53 – ST 700 Basic Transmitter - Flange Adapter Removal and
Replacement
Refer to the instructions included with the kit for removal and replacement procedures.
To Next Page
Loading...
