Honeywell SmartLine ST 700 - Data Entry; Table 15 -Two-Button Data Entry

Page 72 ST 700 SmartLine Pressure Transmitters User’s Manual Revision 13
5.3.3 Data Entry
Data entry is performed from left to right. Select a character / digit by pressing  buttons, and then
press  to advance to the next character position to the right. Select the cross-hatch character ▒ to
terminate the entry or if the final character is already a space character, just press << again.
All numeric entries are clamped at the low or high limit if needed. You can determine the low and
high limit for a parameter by selecting either the H or L character while the cursor is positioned over
the left-most digit and press  button. The display will show the selected limit.
For numeric entry sign is required to be entered only for negative numbers. For positive number, select
space and move ahead.
Table 14 –Two-Button Data Entry
Screen
Symbol
Numeric data entry
H
Display the high limit for this parameter.
This symbol only appears in the left-most
position of the data entry field.
L
Display the low limit for this parameter.
This symbol only appears in the left-most
position of the data entry field.
<<
Terminate the numeric entry
0 thru 9,
Minus,
Decimal
These characters are used to enter
numeric values. The minus sign only
appears in the left-most digit.