Revision 12 ST 700 SmartLine Pressure Transmitters User’s Manual Page 155
12.8.2 Startup Tasks
After completing the installation and configuration tasks for a transmitter, you are ready to start up the
process loop. Startup usually includes:
• Checking zero input
• Reading inputs and outputs
• Applying process pressure to the transmitter.
The actual steps in a startup procedure vary based on the type of transmitter and the measurement
application. In general, the procedures in this section are based on using Honeywell MC Toolkit to
check the transmitter input and output under static process conditions, and make adjustments as
required initiating full operation with the running process. Note that similar checks can be made using
the optional external 2-button assembly, where the transmitter is equipped. Operation with the 2-
button assembly is discussed in the Operation section.
When the standard display is connected, the two-button assembly for the standard display is present.
The buttons will function 1 second after powering up.
To Next Page
Loading...
