Honeywell SmartLine ST 700 - Safety Certification Information; Transmitter Adjustments; Display Options -Standard Display; Table 3 - Available Display Characteristics

Page 6 ST 700 SmartLine Pressure Transmitters User’s Manual Revision 13
2.3 Safety Certification Information
An “approvals” name plate is located on the bottom of the electronics housing assy; see Figure 1 for
exact location. The approvals name plate contains information and service marks that disclose the
transmitter compliance information.
Refer to Section Appendix A in this document for safety certification requirements and details.
2.4 Transmitter Adjustments
Zero and Span adjustments are possible in ST 700 standard transmitter with the optional 3 button and
two-button assemblies.
You can also use the Honeywell MC Toolkit or other third-party hand-held configurator to make
adjustments to the ST 700 standard transmitter. Alternately, certain adjustments can be made through
the Experion or Universal Station, if the transmitter is digitally integrated with a Honeywell Experion
or TPS system.
2.5 Display Options – Standard Display
Table 3 – Available Display Characteristics
Basic display
• Suitable for basic process needs.
• 360
o
rotation in 90
o
Increments.
• 2 lines, 16 characters.
• Standard units of measurement: Pa, KPa, MPa, KGcm
2
, TORR, ATM,
inH
2
O, mH
2
O, bar, mbar, inHg, FTH
2
O, mmH
2
O, MMHG, & PSI.
• Diagnostic messaging.
• Square root output indications.
Standard
display
• 360
o
rotation in 90
o
Increments.
• 2 lines, 8 characters.
• Standard units of measurement: Pressure Units:
o atm, bar, ftH
2
O68F, gf/cm
2
, inH2O39F, inH
2
O60F, inH
2
O68F, inHg0C,
kgf/cm
2
, kPa, mbar, mmH
2
O4C, m, mH
2
O68F, mmHg0C , MPa, Pa,
psi, Torr, mH
2
O4C, cmH
2
O4C
• Flow Units (DP models only):
o m3/hr, kg/hr, MT/hr, L/sec, L/hr, SCFH, CFH, gal/hr, bbl/hr, I/gal/hr,
%, SCFD, gal/min, Ib/hr, Ib/min, SCFM, MSCFH, MMSCFH.
• Diagnostic messaging.