Honeywell SmartLine ST 700 - Figure 7 - ST 700 Standard Transmitter - Inline Model Mounted to an Optional Bracket; Figure 8 - ST 700 Standard Transmitter - Rotating the Electronics Housing

Page 18 ST 700 SmartLine Pressure Transmitters User’s Manual Revision 13
Figure 7 – ST 700 Standard Transmitter - Inline Model Mounted to an
Optional Bracket
3. Loosen the set screw on the outside neck of the transmitter one (1) full turn.
4. Rotate the electronics housing a maximum of 180
o
left or right from the center to the position
you require, and tighten the set screw using a 4mm metric socket head wrench. See the
following example and Figure 8.
Example: Rotating the electronics housing
Figure 8 – ST 700 Standard Transmitter - Rotating the Electronics
Housing
The mounting position of AP models STA722 and STA72L becomes critical as the
transmitter spans become smaller. A maximum zero shift of 2.5mmHg for these models can
result from a mounting position that is rotated 90o from the vertical.
A typical zero-shift of 0.12mmHg or 0.20 inH
2
O can occur for a five (5)-degree rotation from
the vertical