Honeywell SmartLine ST 700 - Table 10 - the Basic Display Menus

Revision 13 ST 700 SmartLine Pressure Transmitters User’s Manual Page 45
Table 10 – The Basic Display Menu
Menu
Submenu/Selection/
Value Entry
Description
Action
LCD Contrast
»»»»»
Adjust the LCD contrast level.
Range from » (1) to »»»»»»»»»
(9)
Default: »»»»»»»(7)
Press  to
enter menu
selection
 and  to
select level.
 to enter
PV Display
Pressure
Pressure Units
Select Process
Variable (PV) to
be shown on the
display from list.
Percent Output
%
Loop Output
mA
PV Decimal
None
Select the PV decimal resolution to
be shown on selected screen from
list.
X.X
X.XX
X.XXX
Pressure Units
atm, bar
ftH
2
O @ 68ºF
gf/cm
2
inH
2
O @ 39ºF
inH
2
O @ 60ºF
inH
2
O @ 68ºF
inHg @ 0ºC
kgf/cm
2
, kPa
mbar,
mmH
2
O @ 4ºC,
mmH
2
O @ 68ºF,
mmHg @ 0ºC,
MPa, Pa,
psi
Torr,
mHg @ 0ºC
cmH
2
O@4DegC
mH
2
O@4DegC
Choose appropriate engineering
units from list
Zero Correct
Do Correct
Executing this selection corrects the
Zero based on the input pressure
Press  to
enter menu
selection
Press  to
initiate action
LRV Correct
Do Correct
Executing this selection corrects the
LRV based on the input pressure
URV Correct
Do Correct
Executing this selection corrects the
URV based on the input pressure
Reset Corrects
Do Correct
Executing this selection Resets the
Zero, LRV, and URV Corrects back
to Factory values
DAC Zero Trim
Note: Loop must be
removed from
Automatic Control
DAC Zero Trim
This selection allows the loop zero
output 4mA value to be trimmed.
Note: You must connect a current
meter to the transmitter to monitor
the loop output.
Press  to
enter menu
selection
 and  to
select
number.
 to enter
and shift to
the next digit
to the right