Honeywell SmartLine ST 700 - Page 63

Revision 13 ST 700 SmartLine Pressure Transmitters User’s Manual Page 47
Menu
Submenu/Selection/
Value Entry
Description
Action
Flow Cutoff
Single Breakpt
Allows the user to specify a single
breakpoint as the low flow cutoff
point.
This item is only available when the
Transfer Function is set to Square
Root.
Dual Slope
Uses a dual slope formula to
determine the low flow cutoff point.
This item is only available when the
Transfer Function is set to Square
Root.
Flow Breakpoint
##. #%
Enter the low flow cutoff point when
Single Breakpt is selected. Range: 0
to 25.0 %Flow.
Tag ID

Enter Tag ID name up to 8
characters long.
 = any Alphanumeric value
Press  to
enter menu
selection
 and  to
select
Alphanumeric
 to enter
and shift to
next
character to
the right.
Device ID
Unique for each device
Read Only
PV Units
Units of transmitted PV
Install Date
DD MM YYYY
This selection allows the user to
enter the date a transmitter is
installed.
The Install Date is entered in
sequence of Day, Month, and Year,
followed by the new date and the
prompt Write Date to confirm the
entry.
CAUTION: The Install Date can only
be written once in the life of the
transmitter. You cannot erase or
overwrite the Install Date once it has
been written.
Press  to
enter menu
selection
 and  to
select
number
 to enter
and shift to
next digit to
the right.
Read Only
after entered
Firmware
Display
Electronics
Meterbody
Menu item shows the current
Firmware versions of the display,
electronics module and the meter
body
Read Only
Parameter
Protocol
HART
Menu item shows the
communications protocol
DE
Model Key
Identifies the type and range of the
transmitter
Read Only
Parameter
<Exit Menu>