To Next Page

To Previous Page

Task Remarks

Creating a RADIUS scheme Required

Specifying the RADIUS authentication/authorization servers Required

Specifying the RADIUS accounting servers and the relevant parameters Optional

Specifying the shared keys for secure RADIUS communication Optional

Specifying the VPN to which the servers belong Optional

Setting the username format and traffic statistics units Optional

Setting the supported RADIUS server type Optional

Setting the maximum number of RADIUS request transmission attempts Optional

Setting the status of RADIUS servers Optional

Specifying the source IP address for outgoing RADIUS packets Optional

Specifying a backup source IP address for outgoing RADIUS packets Optional

Setting timers for controlling communication with RADIUS servers Optional

Configuring RADIUS accounting-on Optional

Configuring the IP address of the security policy server Optional

Configuring interpretation of RADIUS class attribute as CAR parameters Optional

Enabling the trap function for RADIUS Optional

Enabling the RADIUS client service Optional

Setting the DSCP value for RADIUS packets Optional

Displaying and maintaining RADIUS Optional

Creating a RADIUS scheme

Before performing other RADIUS configurations, follow these steps to create a RADIUS scheme and enter

RADIUS scheme view:

Step Command Remarks

1. Enter system view.

system-view N/A

2. Create a RADIUS scheme and

enter RADIUS scheme view.

radius scheme

radius-scheme-name

No RADIUS scheme exists by

default.

NOTE:

RADIUS scheme can be referenced by multiple ISP domains at the same time.

Specifying the RADIUS authentication/authorization servers

You can specify one primary authentication/authorization server and up to 16 secondary

authentication/authorization servers for a RADIUS scheme. When the primary server is not available, the

switch searches for the secondary servers in the order they are configured. The first secondary server in

active state is used for communication.

If redundancy is not required, specify only the primary server.

HP 3600 v2 Series Configuration Guide

Other manuals for HP 3600 v2 Series