340
# Configure the user authentication method as password and service type as SFTP.
[Switch] ssh user client002 service-type sftp authentication-type password
2. Establish a connection between the SFTP client and the SFTP server:
The switch supports a variety of SFTP client software. The following example uses PSFTP of PuTTy
Version 0.58.
NOTE:
PSFTP supports only password authentication.
To establish a connection to the remote SFTP server:
a. Run the psftp.exe to launch the client interface as shown in Figure 102,
and enter the following
command:
open 192.168.1.45
b. Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
Figure 102 SFTP client interface
To Next Page
Loading...
