6-34 ES User’s Guide
Calibrating for Increased Measurement Accuracy
Saving and Recalling the Calibration
Recalling the Calibration
Measurement calibration information is linked to the instrument state
and measurement parameters for which the calibration was done.
Therefore, a saved calibration can be recalled and used for multiple
instrument states as long as the measurement parameter, frequency
range, and number of points are compatible. To recall your calibration
from the analyzer’s internal non-volatile RAM disk, volatile RAM disk,
or a floppy disk in the built-in disk drive:
1. Press and press the key that
corresponds to the location where your desired file exists.
2. If necessary, change directories to the directory that contains the
desired file as described in “To Use Directory Utilities” on page 4-65.
3. Press and turn the front panel knob to move the
highlighted bar to the file you want to recall.
4. Press to recall the desired file to the network
analyzer.
NOTE Refer to “Saving and Recalling Measurement Results” on page 4-55 for
more information on saving, recalling, renaming, and copying files.
SAVE RECALL