HP BladeSystem c3000 Setup And Installation

Troubleshooting 79
Location errors
Location (installation) errors occur when the component is not installed in the appropriate bay. Location
errors can occur on blades, storage blades, power supplies, and fans.
To correct a location error:
1. Use the arrow buttons to navigate to Fix This, and press OK.
2. Review and complete the corrective action suggested by the Insight Display. Remove the indicated
component, and install it into the correct bay. The Insight Display will indicate the correct bay number.
Configuration errors
Configuration errors can occur if the interconnect modules are installed in the wrong bays or if mezzanine
cards are installed in the wrong connectors in the blade. Configuration errors can occur on blades and
interconnect modules.
To correct a configuration error:
1. Use the arrow buttons to navigate to Fix This, and press OK.
2. Review and complete the corrective action suggested by the Insight Display. Depending on the error
received, do one of the following:
o Remove the indicated interconnect module and install it into the correct bay (the Insight Display
indicates the correct bay).
o Remove the blade to correct the mezzanine card installation (the Insight Display will indicate the
correct bay). For information on installing the mezzanine card, see the server-specific user guide on
the Documentation CD.
Device failure errors
Device failure errors occur when a component has failed. Device failure errors can occur on all components,
including:
• Server blades
• Storage blades
• Power supplies
• Interconnect modules
• Onboard Administrator modules
• Fans
• AC power inputs
To correct a device failure error:
1. Use the arrow buttons to navigate to Fix This, and press OK.
2. Review and complete the corrective action suggested by the Insight Display. In most cases, you must
remove the failed component to clear the error.
3. Replace the failed component with a spare, if applicable.
NOTE: If the device failure error is an AC power input failure error, you must have the failed AC
input repaired to clear the error.

HP BladeSystem c3000 Specifications

General

Brand	HP
Model	BladeSystem c3000
Category	Enclosure
Language	English