HP DesignJet Z5600 - Configure firmware updates; Set remote printing preferences

●
Proxy > Primary port: Enter the proxy port number, zero by default.
●
Proxy > Restore factory settings: Return to the initial default settings.
If you have trouble with your Internet connection, see Cannot connect to the Internet on page 159.
Congure rmware updates
You can choose from the Embedded Web Server or from the front panel whether and how to download
rmware updates.
NOTE: If an administrator password has been set, it will be required to change these settings.
●
In the Embedded Web Server: select Setup > Firmware update.
●
Using the front panel: press , then , then Updates > Firmware update.
The following settings are available:
●
Check: If you select Automatically (the default setting), the printer will check automatically every week
(or after the printer has been restarted seven times, whichever happens rst) whether new rmware is
available. If you select Manually, the printer will not check automatically; you can check manually
whenever you like.
●
Download: If you select Automatically (the default setting), the printer will automatically download
new rmware whenever it becomes available. If you select Manually, you will be asked to approve each
download.
NOTE: Downloading the rmware does not mean that you have installed it in your printer. To install
the new rmware, you must conrm the installation manually.
●
Firmware update information: Information about the rmware currently installed
●
Firmware update history: A list of rmware versions that have been installed in the printer. It is usually
possible to reinstall the version immediately before the version that is currently installed, if you have
some problem with the current version.
Set remote printing preferences
At the front panel, press , then , then Setup > Printing preferences to dene the default properties
of jobs sent to your printer from remote locations.
●
Printer margins: Choose between Clip from contents and Add to content.
●
Color: Choose between Color and Grayscale printing.
●
Print quality: Choose between Best, Normal, and Fast.
●
Roll: Choose between Roll 1, Roll 2 (Z5600 only), and Save paper, which automatically chooses the
narrowest roll on which the print will t.
●
Jobs: Choose between On hold and Direct print. By default, jobs from the cloud are On hold. If you
choose Direct print, the front panel will not ask for permission before printing.
ENWW Web Services manual conguration 21