HP DesignJet Z5600 - Embedded Web Server security settings; Disable your HP ePrint connection

●
USB drive: Enable or disable the use of a USB ash drive.
●
Firmware upgrade from USB: Enable or disable rmware updates from a USB ash drive.
●
Enable Internet connection: Enable or disable the Internet connection.
NOTE: If you disable it, you also disable automatic rmware updates.
●
Printer access control: Enable, disable, or change the administrator password.
If an administrator password has been set, it must be given in order to perform the following operations:
●
Change the security settings (including the administrator password itself)
●
Change the conguration of the Internet connection
●
Change the Automatic Firmware Update conguration
●
Enable or disable automatic downloading and/or installation of automatic rmware updates
●
Restore an earlier rmware version
●
Reset factory defaults
NOTE: The administrator password can contain only characters that appear on the front panel's on-screen
keyboard. If you set a new password with the Embedded Web Server, it will reject characters that do not
appear in that limited character set.
Embedded Web Server security settings
From the Embedded Web Server, you can select Setup > Security to control access to the printer in various
ways:
●
Specify separate administrator and guest passwords to control access to the Embedded Web Server
●
Enable or disable Ethernet connection to the printer
●
Enable or disable various groups of front panel operations
●
Use the same security settings that are available in the front panel (see above)
NOTE: An administrator password may be required.
NOTE: For more information, see the Embedded Web Server's online help.
Disable your HP ePrint connection
You can disable the connection to HP ePrint if required for security. At the front panel, press , then ,
then
Connectivity > HP ePrint > HP ePrint settings > HP ePrint connectivity and select Disable.
Disable just puts the remote printing function on hold. If you want to resume using it, you just need to re-
enable it in the same menu. No more setup steps are required.
If you want to disable remote printing permanently, select Disable permanently. To use remote printing
again, you will need to set it up again from scratch (see Set up your Web-connected printer on page 20).
NOTE: You can prevent non-administrators from changing these options by setting an administrator
password in the Embedded Web Server (Setup > Security).
ENWW Control access to the printer 25