38 Chapter 4 General procedures ENWW
Note "Uncoated" is for substrates similar in gloss to copy paper. Matte can be used for substrates like
PVC.
If you use a 75° glossmeter, you can determine the gloss level as follows:
• above 50 percent gloss, click Glossy
• 15 to 50 percent gloss, click Matte
• below 15 percent gloss, click Uncoated.
5 Click Apply. If Uncoated was selected, the following message is displayed:
Very Matte Warning message
If the Configure Color Matching Parameters window appears, continue with step 8.
6 If the ink mix only matches the target color under specific lighting conditions, the
Warning! Metameric window appears.
Warning! Metamerism window
Two colors are considered metameric if under a specified illuminant, they appear
equivalent to the average eye. Under a different illuminant, the colors may vary.
Select the relevant illuminant, and click Apply:
• Outdoor lighting
• Indoor lighting
• Other illuminant
To Next Page
Loading...