HP ProCurve 2910al Switch User Manual

Intelligent Edge Software
Features
Manual
Management
and
Configuration
Advanced
Traffic
Management
Multicast and
Routing
Access
Security
Guide
MAC Lockdown X
MAC Lockout
MAC-based Authentication
Management VLAN
Monitoring and Analysis
Multicast Filtering
Multiple Configuration Files
Network Management Applications (SNMP)
OpenView Device Management
X
X
X
X
X
X
X
X
Passwords and Password Clear Protection
ProCurve Manager (PCM)
Ping
Port Configuration
X
X
X
X
Port Monitoring
Port Security
Port Status
Port Trunking (LACP)
X
X
X
X
Port-Based Access Control (802.1X)
Power over Ethernet (PoE+)
Protocol Filters
Protocol VLANS
X
X
X
X
Quality of Service (QoS)
RADIUS Authentication and Accounting
RADIUS-Based Configuration
Rate-Limiting X
X
X
X
RIP X
xii

HP ProCurve 2910al Switch Specifications

General

Model	HP ProCurve 2910al Switch
Layer	Layer 3
Jumbo Frame Support	Yes
Power Device	Internal power supply
VLAN Support	Yes
Power Supply	100-240 VAC, 50/60 Hz
Ports	24 or 48 x 10/100/1000 ports
Uplink Ports	4 x SFP (mini-GBIC)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF, BGP, IGMP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, SNMP 2c, HTTP, TFTP
Features	VLAN, QoS, IPv6, ACLs
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3af
Operating Temperature	0 to 45°C
Operating Humidity	15% to 95% (noncondensing)
Power over Ethernet (PoE)	PoE+ (802.3at) on PoE+ models, PoE (802.3af) on PoE models