To Next Page

To Previous Page

Switch Memory and Configuration

Using the Menu and Web Browser Interfaces To Implement Configuration Changes

To save and

implement the

changes for all

parameters in this

screen, press the

[Enter] key, then

press [S] (for S

ave).

To cancel all

changes, press the

[Enter] key, then

press [C] (for C

ancel)

Figure 6-4. Example of Pending Configuration Changes You Can Save or Cancel

Note If you reconfigure a parameter in the CLI and then go to the menu interface

without executing a write memory command, those changes are stored only in

the running configuration (even if you execute a Save operation in the menu

interface). If you then execute a switch boot command in the menu interface,

the switch discards the configuration changes made while using the CLI. To

ensure that changes made while using the CLI are saved, execute write memory

in the CLI before rebooting the switch.

Rebooting from the Menu Interface

■ Terminates the current session and performs a reset of the operating

system

■ Activates any configuration changes that require a reboot

■ Resets statistical counters to zero

(Note that statistical counters can be reset to zero without rebooting the

switch. See “To Display the Port Counter Summary Report” on page 14.)

To Reboot the switch, use the Reboot Switch option in the Main Menu. (Note

that the Reboot Switch option is not available if you log on in Operator mode;

that is, if you enter an Operator password instead of a manager password at

the password prompt.)

6-11

HP ProCurve Management And Configuration Guide

Other manuals for HP ProCurve