EasyManuals Logo

HP ProCurve Management And Configuration Guide

HP ProCurve
690 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #589 background imageLoading...
Page #589 background image
Troubleshooting
Troubleshooting Approaches
Troubleshooting Approaches
Use these approaches to diagnose switch problems:
Check the ProCurve Networking web site for software updates that may
have solved your problem: www.procurve.com
Check the switch LEDs for indications of proper switch operation:
Each switch port has a Link LED that should light whenever an active
network device is connected to the port.
Problems with the switch hardware and software are indicated by
flashing the Fault and other switch LEDs.
Refer to the Installation Guide shipped with the switch for a descrip-
tion of the LED behavior and information on using the LEDs for
troubleshooting.
Check the network topology/installation. Refer to the Installation Guide
shipped with the switch for topology information.
Check cables for damage, correct type, and proper connections. You
should also use a cable tester to check your cables for compliance to the
relevant IEEE 802.3 specification. Refer to the Installation Guide shipped
with the switch for correct cable types and connector pin-outs.
Use ProCurve Manager to help isolate problems and recommend solu-
tions.
Use the Port Utilization Graph and Alert Log in the web browser interface
included in the switch to help isolate problems. Refer to Chapter 5, “Using
the ProCurve Web Browser Interface” for operating information. These
tools are available through the web browser interface:
Port Utilization Graph
Alert Log
Port Status and Port Counters screens
Diagnostic tools (Link test, Ping test, configuration file browser)
For help in isolating problems, use the easy-to-access switch console built
into the switch or Telnet to the switch console. Refer to chapters 3 and 4
for operating information on the Menu and CLI interfaces included in the
console. These tools are available through the switch console
Status and Counters screens
Event Log
Diagnostics tools (Link test, Ping test, configuration file browser, and
advanced user commands)
C-5

Table of Contents

Other manuals for HP ProCurve

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve and is the answer not in the manual?

HP ProCurve Specifications

General IconGeneral
BrandHP
ModelProCurve
CategorySwitch
LanguageEnglish

Related product manuals