To Next Page

To Previous Page

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

ProCurve(config)# show snmp-server

SNMP Communities

Community Name MIB View Write Access

---------------- -------- ----------- -

public Manager Unrestricted

Trap Receivers

Link-Change Traps Enabled on Ports [All] : All

Send Authentication Traps [No] : No

Address Community Events Sent in Trap

---------------------- ---------------- ------------------

10.28.227.200 public All

Figure 14-10. Example of Show SNMP-Server with Link-Change Traps Enabled

Configuring the Source IP Address for SNMP Requests

and Traps

SNMP-Server Source IP Address Commands Page

show snmp-server 14-26

snmp-server response-source [dst-ip-of-

request | IP-ADDR | loopback<0-7>]

14-25

snmp-server trap-source [ IP-ADDR |

loopback<0-7>]

14-25

The switch uses the interface IP address as the source IP address in the IP

header when sending a response to SNMP requests. For multi-netted

interfaces, the source IP address is the outgoing interface IP address, which

may be different from the IP address in the destination field of the IP header

of the request. It is sometimes desirable for security reasons to send SNMP

replies from the same IP address as the one on which the corresponding SNMP

14-24

HP ProCurve Management And Configuration Guide

Other manuals for HP ProCurve