--------
----------
---- ---------------------------------------- -------- ---------- ----------
----- ---------- -------- -------
Redundancy (Switch 8212zl)
Displaying Management Information
Standby Console> show redundancy
Settings
Mgmt Redundancy : Enabled
Statistics
Failovers : 1
Last Failover : Mon Sep 26 09:50:40 2005
Slot Module Description
The active management module was last booted from
secondary flash. The standby management module
was last booted from primary flash.
Status SW Version Boot Image
MM1 ProCurve J9092A Management Module 8200zl Active K.12.30 Secondary
MM2 ProCurve J9092A Management Module 8200zl Standby K.12.30 Primary
FM1 ProCurve J9093A Fabric Module 8200zl Enabled
FM2 ProCurve J9093A Fabric Module 8200zl Enabled
Figure 15-19. Example of Show Redundancy Command for Standby Module
Show Flash
You can display the flash information on the standby module, as shown in
Figure 15-20. The Default Boot field displays which flash image will be used
for the next boot.
Standby Console> show flash
Image Size(Bytes) Date Version
Primary Image : 7493854 03/21/07 K.12.30
Secondary Image : 7463821 03/05/07 K.12.30
Boot Rom Version: K.12.10
Default Boot : Primary
Will boot from primary flash
on the next boot.
Figure 15-20. Example of Show Flash Command for Standby Module
Show Version
You can display the version information on the standby module, as shown in
Figure 15-21. The Boot Image field displays which flash image was last booted
from, even if the boot set-default command has been set to change the flash
15-27
To Next Page
Loading...
Need help?
General