Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
request was received. You can configure this capability with the snmp-server
response-source and snmp-server trap-source commands.
Syntax: [no] snmp-server response-source [dst-ip-of-request | IP-ADDR |
loopback<0-7>]
Allows you to specify the source IP address of the SNMP
response pdu. The default SNMP response pdu uses the IP
address of the active interface from which the SNMP response
was sent as the source IP address.
The no form of the command resets the switch to the default
behavior (compliant with rfc-1517).
Default: Interface IP address
dst-ip-of-request: The destination IP address of the SNMP
request pdu that will be used as the source IP address in the
SNMP response pdu.
IP-ADDR: The user-specified IP address that will be used as
the source IP address in the SNMP response pdu.
loopback <0-7>: The IP address configured for the specified
loopback interface will be used as the source IP address in
the SNMP response pdu. In the case of multiple addresses,
the lowest alphanumeric address will be used.
For example, to use the destination IP address as the source IP address, enter
this command:
ProCurve(config)# snmp-server response-source
dst-ip-of-request
To configure the source IP address for a generated trap pdu, enter this
command.
Syntax: [no] snmp-server trap-source [ IP-ADDR | loopback<0-7>]
Allows you to specify the source IP address for the trap pdu.
The no form of the command resets the switch to the default
behavior (compliant with rfc-1517).
Default: Interface IP address
14-25
To Next Page
Loading...
Need help?
General