Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
IP-ADDR: The user-specified IP address that will be used as
the source IP address in the generated trap.
loopback <0-7>: The IP address configured for the specified
loopback interface will be used as the source IP address in
the generated trap pdu. In the case of multiple addresses, the
lowest alphanumeric address will be used.
Note The snmp-server response-source and snmp-server trap-source commands
configure the source IP address for IPv4 interfaces only.
The show snmp-server command displays the policy configuration:
ProCurve_8212(config)# show snmp-server
SNMP Communities
Community Name MIB View Write Access
---------------- -------- ----------- -
public Manager Unrestricted
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Send Authentication Traps [No] : No
Address | Community Events Sent in Trap
---------------------- ---------------- ------------------
Excluded MIBs
Snmp Response Pdu Source-IP Information
Selection Policy : dstIpOfRequest
Trap Pdu Source-IP Information
Selection Policy : Configured IP
Ip Address : 10.10.10.10
Figure 14-11. An Example of Show SNMP-Server with Response Configuration
14-26
To Next Page
Loading...
Need help?
General