Time Protocols
TimeP: Viewing, Selecting, and Configuring
If SNTP is the selected time synchronization method, show timep still lists the
TimeP configuration even though it is not currently in use:
Even though, in this example, SNTP is the
current time synchronization method, the
switch maintains the TimeP
configuration.
Figure 9-14. Example of TimeP Configuration When TimeP Is Not the Selected Time Synchronization
Method
Syntax: show management
This command can help you to easily examine and compare
the IP addressing on the switch. It lists the IP addresses for
all time servers configured on the switch, plus the IP addresses
and default gateway for all VLANs configured on the switch.
Figure 9-15. Example of Display Showing IP Addressing for All Configured Time
Servers and VLANs
9-19
To Next Page
Loading...
Need help?
General