EasyManua.ls Logo

HP ProCurve - Page 471

HP ProCurve
690 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Redundancy (Switch 8212zl)
Event Log Messages
# System Message Severity Description
268 Mgmt Module [1 or 2] - Failover
occurred
warn A switchover occurred because of a hardware or
software failure or because the management
module reset button was pressed.
RMON_SYSTEM_MGMT_FAILOVER
269 Mgmt Module [1 or 2] - User initiated
switchover occurred
info The user has initiated switchover using the
redundancy switchover command so that the other
management module can become the active
management module.
RMON_SYSTEM_MGMT_SWITCHOVER
270 Mgmt Module [1 or 2] - Offline
(incompatible SW versions)
warn The software version in the specified management
module is not compatible with the other module and
it has gone offline.
RMON_SYSTEM_MGMT_INCOMPAT_OS
271 Other management module is not in
standby, shutdown request ignored
warn A shutdown request is ignored because the
standby module is not in standby mode. A
management module must be in active or standby
mode to be shut down. The module goes into a
“down” state which allows you to safely swap it
out.
RMON_SYSTEM_MGMT_HSBUTTONERR
272 Mgmt Module [1 or 2] Offline
(shutdown)
info The specified management module is offline
because of a shutdown.
RMON_SYSTEM_MGMT_SHUTDOWN
273 Resetting Mgmt Module [1 or 2] <reason
for reset>
info The indicated management module is being reset
for the reason displayed.
RMON_SYSTEM_MGMT_RESET_REASON
537 Syncing [primary |secondary] OS to
standby [started | completed]
info This message is logged when the OS begins
synchronizing to the standby module. It displays the
status of the synchronization.
RMON_SYSTEM_OS_SYNC
538 Standby <boot image | default boot>
updated, rebooting standby
info This message is logged when the standby’s
management module boot image is overwritten,
requiring a reboot.
RMON_SYSTEM_STANDBY_REBOOT
539 Initial active to standby sync <started |
completed>
info Indicates the beginning or end of the initial
synchronization of the active management
module’s flash image to the standby management
module.
RMON_SYSTEM_INITIAL_SYNC
15-47

Table of Contents

Other manuals for HP ProCurve

Related product manuals