File Transfers
Downloading Switch Software
Enables/Disables TFTP.
Note: If SFTP is enabled, this field will be set to No. You
cannot use this field to enable TFTP if SFTP is enabled.
Attempting to do so produces an Inconsistent value
message in the banner below the Actions line.
Figure A-6. Using the Menu Interface To Disable TFTP
■ While SFTP is enabled, TFTP and auto-TFTP cannot be enabled from the
CLI. Attempting to enable either non-secure TFTP option while SFTP is
enabled produces one of the following messages in the CLI:
SFTP must be disabled before enabling tftp.
SFTP must be disabled before enabling auto-tftp.
Similarly, while SFTP is enabled, TFTP cannot be enabled using an SNMP
management application. Attempting to do so generates an “inconsistent
value” message. (An SNMP management application cannot be used to
enable or disable auto-TFTP.)
■ To enable SFTP by using an SNMP management application, you must first
disable TFTP and, if configured, auto-TFTP on the switch. You can use
either an SNMP application or the CLI to disable TFTP, but must use the
CLI to disable auto-TFTP. The following two CLI commands disable TFTP
and auto-TFTP on the switch.
A-12
To Next Page
Loading...
Need help?
General