EasyManuals Logo

HP R1500 - UPS XR User Manual

HP R1500 - UPS XR
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
ERM installation 58
4.
Insert screws through the mounting rail into the cage nuts or clip nuts.
5. Tighten the wing nuts or hex nuts.
Preparing the rails for integrated shipping
If the unit is to be shipped in a rack:
1. Remove the hex nuts from the mounting rail.
2. Install the rail reinforcement plates and tighten using the hex nuts with captive washers, included in the
kit, instead of the nuts included with the rail.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP R1500 - UPS XR and is the answer not in the manual?

HP R1500 - UPS XR Specifications

General IconGeneral
TopologyLine Interactive
Input ConnectionIEC 320 C14
Battery TypeSealed Lead Acid (SLA)
Form FactorRackmount
Nominal Output Voltage230V
Nominal Input Voltage230V
Input Frequency50/60 Hz
Typical Backup Time at Full Load5 minutes
Transfer Time4-8 ms
Hold-up Time10 ms
Input Voltage Range160 - 286 VAC
Interface PortUSB
Battery Recharge Time3 hours
Communication PortsUSB
WaveformSine wave

Related product manuals