HP R1500 - UPS XR User Manual

Communication 79
Metering
The Output and Load Receptacle meter readings differ between a parallel system and a standalone UPS. In
a parallel system, one UPS reads the Load Receptacle value for the total system (the others read zero), but
each UPS displays its own Output value. For example, in a two-unit parallel system with one Anderson load
connection for 12 kVA, the Load Receptacle current would read 12 kVA on one UPS and zero on the other
UPS, but the Output measurement would be 6 kVA on each UPS (half the total). In a standalone UPS, the load
can be connected from the outlet cord or the Anderson load connector. The Output measurement would be
the total load on the UPS, and the Load reading would be the portion supplied by the Anderson load
connector.

HP R1500 - UPS XR Specifications

General

Topology	Line Interactive
Input Connection	IEC 320 C14
Battery Type	Sealed Lead Acid (SLA)
Form Factor	Rackmount
Nominal Output Voltage	230V
Nominal Input Voltage	230V
Input Frequency	50/60 Hz
Typical Backup Time at Full Load	5 minutes
Transfer Time	4-8 ms
Hold-up Time	10 ms
Input Voltage Range	160 - 286 VAC
Interface Port	USB
Battery Recharge Time	3 hours
Communication Ports	USB
Waveform	Sine wave