Power management 80
Power management
HP UPS Power Protection Agent overview
The HP UPS Power Protection Agent runs on a local or network server and allows the management module
to gracefully shut down the operating system of that server and optionally run a script during power failure.
Install the agent on any machine that is powered by the UPS and any machine that the management module
uses to initiate a command.
NOTE: If you are an existing HP Power Manager user, you must uninstall the HPPM Remote
Agent before installing the UPS Power Protection Agent.
Features
• Monitors the status of the UPS and performs diagnostics
• Manages a graceful shutdown of attached equipment during a utility power failure
• For UPSs with multiple load segments, the management module, manages independent UPS load
segments to provide separate power control of connected equipment
NOTE: The HP 3 Phase UPSs have only one load segment.
• Prioritizes the timing of equipment shutdown and reboots connected equipment by load segment
• Delays restart by load segment after a power outage to sequence the startup of system components
• Shuts down and reboots the UPS and attached equipment, based on a user-specified schedule
• Sends customized email and broadcast notification messages and SNMP traps
• Issues computer commands at power failure
• Displays logs for analysis
• Supports a redundant UPS configuration
• Includes enhanced HP SIM integration
• Includes multi-language support
• Supports serial- and network-attached server communications
• Supports a customizable Events script
To Next Page
Loading...
