EasyManua.ls Logo

HP Xw8200 - Workstation - 1 GB RAM

HP Xw8200 - Workstation - 1 GB RAM
201 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
POWER ON SELF TEST (POST) AND ERROR MESSAGES 135
Chapter 5
214—DIMM Configuration
Warning
DIMMs not installed correctly (not
paired correctly).
Refer to “Memory” on page 76 for the correct memory
configurations and reseat the DIMMs accordingly.
215—Memory Mismatch
Warning
There are one or more mismatched
pairs of DIMMs between channel A
and channel B. Some memory has
been disabled. Install matching pairs
or remove the mismatched DIMMs
from channel B.
Refer to “Memory” on page 76 for the correct memory
configurations and reseat the DIMMs accordingly.
216—Memory Size Exceeds
Maximum Supported
The amount of memory installed
exceeds that supported by the
hardware.
1 Verify how much memory your system can
support.
2 Remove the excessive memory.
219—ECC Memory Module
Detected.
ECC modules not supported on this
platform.
Remove the EDD module.
301—Keyboard Error Keyboard failure. 1 Reconnect keyboard with workstation turned off.
2 Check connector for bent or missing pins.
3 Be sure that none of the keys are pressed.
4 Replace keyboard.
303—Keyboard Controller
Error
I/O board keyboard controller. 1 Reconnect keyboard with workstation turned off.
2 Replace the system board.
304—Keyboard or System
Unit Error
Keyboard failure. 1 Reconnect the keyboard with workstation turned
off.
2 Be sure that none of the keys are pressed.
3 Replace keyboard.
4 Replace system board.
401—Parallel Port 1 Address
Assignment Conflict
IRQ address conflicts with another
device.
Reset the IRQ.
402—Parallel Port 2 Address
Assignment Conflict
IRQ address conflicts with another
device.
Reset the IRQ.
403—Parallel Port 3 Address
Assignment Conflict
IRQ address conflicts with another
device.
Reset the IRQ.
404—Parallel Port Address
Conflict Detected
Both external and internal ports are
assigned to parallel port X.
1 Remove any parallel expansion cards.
2 Clear CMOS.
3 Reconfigure card resources and run Computer
Setup (F10 Setup).
410—Audio Interrupt Conflict IRQ address conflicts with another
device.
Reset the IRQ.
411—Network Interface Card
Interrupt Conflict
IRQ address conflicts with another
device.
Reset the IRQ.
Table 5-18 POST Error Messages (Continued)
Screen Message Probable Cause Recommended Action

Table of Contents

Other manuals for HP Xw8200 - Workstation - 1 GB RAM

Related product manuals