Memory
This section presents memory module (DIMM) configuration information and removal/installation
procedures.
Supported DIMM configurations
The computer supports these DIMM configurations:
●
Four DIMM slots
●
Memory configuration from 1 GB to 16GB
●
No support for mirroring
●
No support for DIMM sparing
●
Error checking and correcting (ECC) and non-ECC DIMMs are supported.
DIMM installation guidelines
●
Install only HP-approved DDR3 DIMMs
CAUTION: HP ships only DIMMs that are electrically and thermally compatible with this
computer. Because third-party DIMMs might not be electrically or thermally compatible, they are
not supported by HP.
●
For ECC DIMMs, use only industry-standard ECC unbuffered DIMMs. See
http://www.hp.com/go/
quickspecs to find which DIMMs are compatible with the computer.
DIMM installation order
The numbers in the following figure show the correct installation order for DIMMs.
Figure 5-44 DIMM load order
ENWW Removing and installing components 105
To Next Page
Loading...
Need help?
General