HP Z200 - Small Form Factor Workstation

7 Configuring RAID devices
This chapter describes how to configure SATA RAID devices on all Z series computers and includes
these topics:
Topics
Maximum hard drive configurations on page 162
Configuring SATA RAID devices on page 163
For additional information about configuring RAIDs, see http://www.hp.com/support/RAID_FAQs. For
information about preparing the computer for RAID configuration, see
http://www.hp.com/support/
workstation_manuals.
Maximum hard drive configurations
This section lists the maximum number of hard drives supported on HP computers for RAID
configurations.
NOTE: This section applies to internal computer configurations that do not use add-in cards and
JBODs.
TIP: Use the table values to determine computer-specific maximum number of hard drives as
discussed the sections below.
Table 7-1 Maximum hard drives
Workstation SATA hard drive SATA SFF
*
hard drive
Z800 5 6
Z600 3 4
Z400 4 4
Z200 3 0
Z200 SFF 2 2
*
Small form factor hard drive
162 Chapter 7 Configuring RAID devices ENWW