HP Z200 - Small Form Factor Workstation Maintenance And Service Guide

Bezel
This section describes how to remove and install the front chassis bezel.
Removing the front bezel
To remove the front bezel:
1. Prepare the computer for servicing by following the
Predisassembly procedures on page 68.
CAUTION: Failure to follow the predisassembly procedures can result in equipment damage or
data loss.
2. Remove the access panel (see Removing the access panel on page 71).
3. If the security screw is installed (next to the middle front bezel release tab), remove the screw.
(See
Front bezel security on page 73.)
4. Lift the release tabs (1), and then rotate the front bezel off the chassis (2).
Figure 5-4 Removing the front bezel
Installing the front bezel
To install the front bezel:, align the tabs discussed in the previous section and rotate the bezel until it
snaps in place.
1. Align the tabs discussed in the previous section and rotate the bezel until it snaps in place.
2. If you are using the bezel security screw, replace the screw next to the middle front bezel release
tab.
72 Chapter 5 Replacing components ENWW

HP Z200 - Small Form Factor Workstation Specifications

General

Brand	HP
Model	Z200 - Small Form Factor Workstation
Category	Desktop
Language	English