HP zl User Manual

102
Specify a New Boot Image Through the CLI
1. Find the name of your new system image by listing all the image files on the Topspin chassis. Enter
the dir image command.
2. Copy the displayed system-image (this will be pasted into the boot-config command).
3. Specify the new boot image.
Enter boot-config
primary-image-source , then paste the then paste the copied image file
name.
Syntax:
Example
4. Show the new system -image.
Example
Reboot the System
The complete reboot process is described in the other chapters.
• Reboot the system through the GUI (refer to page 37).
• Reboot the system through the CLI (refer to page 43).
Topspin-360# dir image
=========================================================================
Existing Boot-Images on System
=========================================================================
slot date-created size file-name
-------------------------------------------------------------------------
1 Tue Feb 25 16:14:15 2003 23198989 TopspinOS-2.0-build491
1 Thu Jan 1 00:18:52 1970 1024 TopspinOS-2.0/build491
1 Tue Feb 25 16:17:04 2003 1024 TopspinOS-2.0/build497
Topspin-360#
boot-config primary-image-source image-directory-name
Topspin-360# configure
Topspin-360(config)# boot-config primary-image-source
TopspinOS-1.1.3/build497
Topspin-360(config)# exit
Topspin-360# show boot-config
=========================================================================
System Boot Configuration
=========================================================================
slot-id : 1
sw-version : TopspinOS-1.1.3/build491
last-image-source : TopspinOS-1.1.3/build491
primary-image-source : TopspinOS-1.1.3/build497

HP zl Specifications

General

Model	HP zl
Managed	Yes
Dimensions	Varies by model
Weight	Varies by model
Layer	Layer 3
Power Supply	Redundant power supplies supported
Management	CLI, Web, SNMP
PoE	Optional
Stacking	Yes
Jumbo Frames	Supported
VLANs	Supported
MAC Address Table	Up to 64, 000 entries
Operating Temperature	0°C to 45°C
Product Series	ProCurve/Aruba zl Series