18
• Fibre Channel gateways.
f. If you have multiple InfiniBand switches in your fabric:
• Exchange the partition configuration between switches by enabling database
synchronization, if you have not already done so. Refer to “Enable/Disable Database
Synchronization” on page 84.
Set User Levels and Passwords
Change Default User Name and Password
For security purposes, since multiple users exist on the system, it is highly recommended that you
change the default passwords after initial configuration.
See “Understanding Usernames and Passwords” on page 46 for more information.
1. Log in to the CLI as a super user. Use the default username (super) and the default password
(super) if they have not already been changed (refer to page 47).
2. Enter the privileged-user mode.
3. Enter the global-configuration mode.
4. Enter the
username
command and the
password
keyword to change the user account and user
password.
Use the default user name and password if they have not already been changed (refer to page 47).
The user name and password are alphanumeric strings of up to 34 characters each.
5. Repeat step 4 to change additional usernames and passwords.
Example
6. Exit the global-configuration mode.
7. Use the
show user
command to verify changes.
Only a user with unrestricted privileges may view user information.
Topspin-360# Login: super
Password: xxxx
Topspin-360>
enable
Topspin-360#
configure
Topspin-360(config)#
username
ib-fc_admin
password
ibFcAdmin
Topspin-360(config)# username ib-fc_admin communitystring
ibFc-commStr
Topspin-90> show user all
=========================================================================
User Information
=========================================================================
username : admin
password : topspin
snmp-community : justatest
permission-level : ib-rw, ip-ethernet-rw, fc-rw
admin-status : enabled
num-logins : 0
num-unsuccessful-logins : 0
last-login :
last-unsuccessful-login :
Topspin-90>
To Next Page
Loading...
Need help?
General
