49
Adding New Users
To add a new user account for both CLI and Element Manager access:
1. Log in as the unrestricted user.
Only a user with unrestricted permissions may add new user accounts.
2. Enter the privileged-user mode.
3. Enter the global-configuration mode.
4. Create the user account and user password.
The user name and password are alphanumeric strings up to 34 characters each.
where
ib-admin
is the name assigned to this user account,
password
is a mandatory keyword,
and
ib-passwd
is the password for this user account.
5. Assign an SNMP community string to the new user account.
The user must have an SNMP community string to begin an Element Manager session. If you do
not want users to have SNMP access to the Topspin system, do not assign them a community string.
By default, a new user account has a null or empty community string.
where,
ib-admin
is the name of the user account,
community-string
is a mandatory keyword.
ib-commStr
is the SNMP community string for this user account.
6. Assign access privileges.
By default, the new user account has read-only access. You may grant write privileges to the user
for functional areas, such as InfiniBand, Ethernet, and Fibre Channel.
7. Enter multiple access privileges in the order shown in “About Roles and Privileges” on page 46.
where,
ib-admin
is the name of the user account,
privilege
is a mandatory keyword, and
ib-rw
,
ip-ethernet-ro
, and
fc-rw
are access privileges. Valid access privileges are
described in “About Roles and Privileges” on page 46.
All new user accounts are now enabled and ready for use.
8. Exit the global-configuration mode.
Topspin-360# Login: super
Password: xxxx
Topspin-360>
Topspin-360> enable
Topspin-360#
Topspin-360# configure
Topspin-360(config)#
Topspin-360(config)# username ib-admin password ib-passwd
Topspin-360(config)# username ib-admin community-string ib-commStr
Topspin-360(config)# username ib-admin privilege ib-rw ip-ethernet-ro fc-rw
To Next Page
Loading...
Need help?
General
