HP zl User Manual

43
Rebooting the System
Reboot a System with a Single Controller
Enter the CLI reload command in privileged EXEC mode. The system prompts for you to verify the
reload. If you had not already saved configuration changes, and the system detects the changes, it
prompts you to save. If you enter yes, the new configuration is stored in startup-config. You may
optionally save the configuration to an alternate file by entering the file name, followed by a
carriage-return.
Example
The system re-initializes itself and then loads the system-image and the startup-config file. Wait a few
minutes and attempt to log onto the chassis.
Topspin-360> enable
Topspin-360# reload
System configuration has been modified. Save?
[yes(default)/no/*.cfg] yes
Proceed with reload? [confirm]
Topspin-360#
Connection to host lost.

HP zl Specifications

General

Model	HP zl
Managed	Yes
Dimensions	Varies by model
Weight	Varies by model
Layer	Layer 3
Power Supply	Redundant power supplies supported
Management	CLI, Web, SNMP
PoE	Optional
Stacking	Yes
Jumbo Frames	Supported
VLANs	Supported
MAC Address Table	Up to 64, 000 entries
Operating Temperature	0°C to 45°C
Product Series	ProCurve/Aruba zl Series