EasyManuals Logo

HP zl User Manual

HP zl
169 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #95 background imageLoading...
Page #95 background image
83
or
Example
View the subnet-prefix of the subnet manager.
View the Global Unique Identifier (guid) of the subnet manager.
View the priority for the subnet manager. The priority number of a subnet manager tells the subnet
manager how to interact with other subnet managers; the highest priority subnet manager becomes
the master.
•View the smKey. The smkey is a 64-bit subnet management key that is assigned to the subnet
manager.
•View the admin-status of the subnet manager. The Administrative Status value is enable or
disable. Disabling a subnet manager places it in an inactive state but leaves it intact in the
configuration. The default is enable.
View the oper-status of the subnet manager. The status is determined by self-detection. The values
are notActive, discovering, or Master. As there is only one subnet manager running on the fabric,
the sm that is running is always designated the master.
notActive indicates the subnet manager has not been enabled or has been disabled.
discovering indicates the subnet manager is sweeping the fabric.
•View the act-count of the subnet manager. The Activity counter increments each time the subnet
manager issues a subnet management packet (SMP) or performs other management activities.
•View the status of the subnet manager. The Status may be active or inactive. If active, it is actively
managing subnets. If inactive, it is not managing subnets.
View the Sweep Interval of the subnet manager. The sweep interval indicates the rate (in seconds)
at which the subnet manager sweeps the fabric for any network changes.
The default is 10 seconds.
•View the Response Timeout of the subnet manager. This is the maximum time allowed between
the port reception of a subnet management packet and the transmission of the associated response.
The default is 2,000 microseconds.
Changing the Subnet Manager Configurations
Change the Priority of a SM
The priority number of a subnet manager tells the subnet manager how to interact with other subnet
managers; the highest priority subnet manager becomes the master. Because multiple subnet managers
Topspin-360# show ib sm config subnet-prefix all
================================================================================
Subnet Manager Information
================================================================================
subnet-prefix : fe:80:00:00:00:00:00:00
guid : 00:05:ad:00:00:01:38:82
priority : 10
sm-key : 00:00:00:00:00:00:00:00
admin-status : enable
oper-status : master
act-count : 216655
status : active
sweep-interval : 10
response-timeout : 400

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP zl and is the answer not in the manual?

HP zl Specifications

General IconGeneral
ModelHP zl
ManagedYes
DimensionsVaries by model
WeightVaries by model
LayerLayer 3
Power SupplyRedundant power supplies supported
ManagementCLI, Web, SNMP
PoEOptional
StackingYes
Jumbo FramesSupported
VLANsSupported
MAC Address TableUp to 64, 000 entries
Operating Temperature0°C to 45°C
Product SeriesProCurve/Aruba zl Series

Related product manuals