HPE FlexNetwork 5130 EI Series Layer 3-Ip Services Configuration Guide

164
Enabling the sending of RA messages
1. Enter system view.
system-view
2. Enter interface view.
interface interface-type interface-number
3. Enable the sending of RA messages.
undo ipv6 nd ra halt
The default setting is disabled.
4. Set the maximum and minimum intervals for sending RA messages.
ipv6 nd ra interval max-interval min-interval
By default, the maximum interval for sending RA messages is 600 seconds, and the minimum
interval is 200 seconds.
The device sends RA messages at random intervals between the maximum interval and the
minimum interval.
The minimum interval should be less than or equal to 0.75 times the maximum interval.
Configuring parameters for RA messages
1. Enter system view.
system-view
2. Enter interface view.
interface interface-type interface-number
3. Configure the prefix information in RA messages.
ipv6 nd ra prefix { ipv6-prefix prefix-length |
ipv6-prefix
/prefix-length } [ valid-lifetime preferred-lifetime
[
no-autoconfig | off-link ] * | no-advertise ]
By default, no prefix information is configured for RA messages, and the IPv6 address of the
interface sending RA messages is used as the prefix information. If the IPv6 address is
manually configured, the prefix uses a fixed valid lifetime of 2592000 seconds (30 days) and a
preferred lifetime of 604800 seconds (7 days). If the IPv6 address is automatically obtained, the
prefix uses the valid lifetime and preferred lifetime configured for the IPv6 address.
4. Configure the default settings for prefixes advertised in RA messages.
ipv6 nd ra prefix default [ valid-lifetime preferred-lifetime
[ no-autoconfig | off-link ] * | no-advertise ]
By default, no default settings are configured for prefixes advertised in RA messages.
5. Turn off the MTU option in RA messages.
ipv6 nd ra no-advlinkmtu
By default, RA messages contain the MTU option.
6. Specify unlimited hops in RA messages.
ipv6 nd ra hop-limit unspecified
By default, the maximum number of hops in RA messages is 64.
7. Set the M flag bit to 1.
ipv6 nd autoconfig managed-address-flag
By default, the M flag bit is set to 0 in RA advertisements. Hosts receiving the advertisements
will obtain IPv6 addresses through stateless autoconfiguration.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English