73
dhcp relay information remote-id { normal [ format { ascii | hex } ] |
string remote-id | sysname }
By default, the padding mode for the Remote ID sub-option is normal, and the padding format
is
hex.
Setting the DSCP value for DHCP packets sent by
the DHCP relay agent
About the DSCP value for DHCP packets sent by the DHCP relay agent
The DSCP value of a packet specifies the priority level of the packet and affects the transmission
priority of the packet.
Procedure
1. Enter system view.
system-view
2. Set the DSCP value for DHCP packets sent by the DHCP relay agent.
dhcp dscp dscp-value
By default, the DSCP value in DHCP packets sent by the DHCP relay agent is 56.
Specifying the DHCP relay agent address for the
giaddr field
Manually specifying the DHCP relay agent address for the
giaddr field
About manually specifying the DHCP relay agent address for the giaddr field
This task allows you to specify the IP addresses to be encapsulated to the giaddr field of the DHCP
requests. If you do not specify any DHCP relay agent address, the primary IP address of the DHCP
relay interface is encapsulated to the giaddr field of DHCP requests.
Procedure
1. Enter system view.
system-view
2. Enter interface view.
interface interface-type interface-number
3. Specify the DHCP relay agent address to be encapsulated in relayed DHCP requests.
dhcp relay gateway ip-address
By default, the primary IP address of the DHCP relay interface is encapsulated in the relayed
DHCP requests.
To Next Page
Loading...
Need help?
General