EasyManuals Logo

HPE FlexNetwork 5130 EI Series Layer 3-Ip Services Configuration Guide

HPE FlexNetwork 5130 EI Series
265 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #175 background imageLoading...
Page #175 background image
165
8. Set the O flag bit to 1.
ipv6 nd autoconfig other-flag
By default, the O flag bit is set to 0 in RA advertisements. Hosts receiving the advertisements
will acquire other configuration information through stateless autoconfiguration.
9. Set the router lifetime in RA messages.
ipv6 nd ra router-lifetime time
By default, the router lifetime is 1800 seconds.
10. Set the NS retransmission timer.
ipv6 nd ns retrans-timer value
By default, an interface sends NS messages every 1000 milliseconds, and the value of the
Retrans Timer field in RA messages is 0.
11. Set the router preference in RA messages.
ipv6 nd router-preference { high | low | medium }
By default, the router preference is medium.
12. Set the reachable time.
ipv6 nd nud reachable-time time
By default, the neighbor reachable time is 30000 milliseconds, and the value of the Reachable
Time field in sent RA messages is 0.
Setting the maximum number of attempts to send
an NS message for DAD
About the maximum number of attempts to send an NS message for DAD
An interface sends an NS message for DAD for an obtained IPv6 address. The interface resends the
NS message if it does not receive a response within the time specified by the
ipv6 nd ns
retrans-timer
command. If the interface receives no response after making the maximum
attempts specified by the
ipv6 nd dad attempts command, the interface uses the IPv6 address.
Procedure
1. Enter system view.
system-view
2. Enter interface view.
interface interface-type interface-number
3. Set the number of attempts to send an NS message for DAD.
ipv6 nd dad attempts interval
The default setting is 1. When the interval argument is set to 0, DAD is disabled.
Configuring ND snooping
About ND snooping
The ND snooping feature is used in Layer 2 switching networks. It learns the source MAC addresses,
source IPv6 addresses, input interfaces, and VLANs of arriving ND messages and data packets to
build the ND snooping table.
ND snooping entries can be used by ND detection to prevent spoofing attacks.

Table of Contents

Other manuals for HPE FlexNetwork 5130 EI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork 5130 EI Series and is the answer not in the manual?

HPE FlexNetwork 5130 EI Series Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork 5130 EI Series
CategorySwitch
LanguageEnglish

Related product manuals