HPE FlexNetwork 5130 EI Series - Common Proxy ARP Configuration Example; Example: Configuring Common Proxy ARP

16
Task Command
Display local proxy ARP status.
display local-proxy-arp
[
interface
interface-type interface-number ]
Common proxy ARP configuration example
Example: Configuring common proxy ARP
Network configuration
As shown in Figure 6, Host A and Host D have the same IP prefix and mask, but they are located on
different subnets separated by the switch. Host A belongs to VLAN 1, and Host D belongs to VLAN 2.
No default gateway is configured on Host A and Host D.
Configure common proxy ARP on the switch to enable communication between the two hosts.
Figure 6 Network diagram
Procedure
# Create VLAN 2.
<Switch> system-view
[Switch] vlan 2
[Switch-vlan2] quit
# Configure the IP address of VLAN-interface 1.
[Switch] interface vlan-interface 1
[Switch-Vlan-interface1] ip address 192.168.10.99 255.255.255.0
# Enable common proxy ARP on VLAN-interface 1.
[Switch-Vlan-interface1] proxy-arp enable
[Switch-Vlan-interface1] quit
# Configure the IP address of VLAN-interface 2.
[Switch] interface vlan-interface 2
[Switch-Vlan-interface2] ip address 192.168.20.99 255.255.255.0