47
Configuring a DHCP policy for dynamic
assignment
About a DHCP policy for dynamic assignment
In a DHCP policy, each DHCP user class has a bound DHCP address pool. Clients matching
different user classes obtain IP addresses and other parameters from different address pools. The
DHCP policy must be applied to the interface that acts as the DHCP server. When receiving a DHCP
request, the DHCP server compares the packet against the user classes in the order that they are
configured.
• If a matching user class is found and the bound address pool has assignable IP addresses, the
server assigns an IP address and other parameters from the address pool. If the address pool
does not have assignable IP addresses, the address assignment fails.
• If no match is found, the server assigns an IP address and other parameters from the default
DHCP address pool. If no default address pool is specified or the default address pool does not
have assignable IP addresses, the address assignment fails.
For successful address assignment, make sure the applied DHCP policy and the bound address
pools exist.
Restrictions and guidelines
A DHCP policy take effect only after it is applied to an interface.
Procedure
1. Enter system view.
system-view
2. Create a DHCP policy and enter DHCP policy view.
dhcp policy policy-name
3. Specify a DHCP address pool for a DHCP user class.
class class-name ip-pool pool-name
By default, no address pool is specified for a user class.
4. Specify the default DHCP address pool.
default ip-pool pool-name
By default, no default address pool is specified.
5. Return to system view.
quit
6. Enter interface view.
interface interface-type interface-number
7. Apply the DHCP policy to the interface.
dhcp apply-policy policy-name
By default, no DHCP policy is applied to an interface.
Enabling DHCP
Restrictions and guideline
You must enable DHCP to make other DHCP configurations take effect.
To Next Page
Loading...
Need help?
General