43
By default, no DHCP address pool exists.
3. Specify the IP address or the name of a TFTP server.
{ Specify the IP address of the TFTP server.
tftp-server ip-address ip-address
By default, no TFTP server IP address is specified.
{ Specify the name of the TFTP server.
tftp-server domain-name domain-name
By default, no TFTP server name is specified.
4. Specify the configuration file name.
bootfile-name bootfile-name
By default, no configuration file name is specified.
Specifying the URL of the configuration file on an HTTP file server
1. Enter system view.
system-view
2. Enter DHCP address pool view.
dhcp server ip-pool pool-name
3. Specify the URL of the configuration file.
bootfile-name url
By default, no configuration file URL is specified.
Specifying a server for DHCP clients
About a server for DHCP clients
Some DHCP clients need to obtain configuration information from a server, such as a TFTP server.
You can specify the IP address of that server. The DHCP server sends the server's IP address to
DHCP clients along with other configuration information.
Procedure
1. Enter system view.
system-view
2. Enter DHCP address pool view.
dhcp server ip-pool pool-name
3. Specify the IP address of a server.
next-server ip-address
By default, no server is specified.
Configuring Option 184 parameters for DHCP clients
About Option 184 parameters for DHCP clients
To assign calling parameters to DHCP clients with voice service, you must configure Option 184 on
the DHCP server. For more information about Option 184, see "Option 184."
Procedure
1. Enter system view.
system-view
2. Enter DHCP address pool view.
To Next Page
Loading...
Need help?
General